This
module combines all of the functions of the Self-Canceling Turn
Signal Module and the Tri-Star Module. Engineered for the custom
builder or to retro-fit motorcycles not equipped with
self-canceling turn signals. Designed for use with individual
momentary type turn signal switches mounted on the left and
right handle bars. Three Turn Signal Timing Modes - Self
Canceling Hazard Mode - Non-Self Canceling Adds brake light
function to turn signals Non-Load Dependent Flash Duration: all
three modes are flash time constant whether using incandescent
or LED lighting.
Features:
- Three Turn Signal Timing Modes -
Self Canceling
- Hazard Mode -
Non-Self Canceling
- Adds brake light function to turn
signals
- Non-Load Dependent Flash
Duration: all three modes are
flash time constant whether using incandescent or LED lighting
- Dependable Solid-state electronic
components.
- Weather Proof -
potted with soft cell technology to
prevent wire chaffing and damage.
Specification:
- Voltage: 12 VDC,
Negative Ground.
- Max Load Capacity: 6 amps per left
or right channel.
- Dimension: 2 1/4” L x 1 5/8” W x
5/8” H
- Mounting: Secure to flat surface
with double sided VHB tape (included).
Five Unique Turn Signal
Modes of Operation
Mode
1 : Press turn signal button for 1 second, turn
signal lights will flash for 7 seconds, then self cancel. This
mode is usually used when changing lanes.
Mode 2 : Press turn signal
button for 2 seconds, turn signal lights will flash for 20
seconds, then self-cancel. This mode is usually used when
slowing down to go around a corner.
Mode 3 : Press turn signal
button for 4 seconds, turn signal lights will flash for 75
seconds, then self-cancel. This mode is usually used when
stopping at a signal light and turn will be made after stopping.
Note: All three modes above can be cancelled by pressing the
same turn signal button a second time.
Mode 4 : Hazard Mode - is
available all the time and will flash until cancelled. To
engage, press both the left and right turn signal buttons for 1
second. To cancel, press both buttons again for one second.
Mode 5 :
Brake Lights - Applying the brakes
will cause the rear Turn Signals to light as long as the brakes
are held. If a turn signal is sent to the rear lights at the
same time it will have priority over the brake lights and cause
the corresponding light to flash. When the turn signal is
canceled the brake light will resume. |
