|
| |
Brake Light Module
|
 |
01001
Brake Light Signal Module
Price: $34.95
|
|
Maximize
your Brake Light Effectiveness with BackOFF. This compact solid state
electronic module converts your ordinary brake light into an attention
getting visual alerting device, creating more visibility and conspicuity
when you are stopped or stopping. With BackOFF-MC installed, when you apply
your brakes, it causes your brake light to automatically emit a visual
alerting signal of 3 short light flashes, followed by 1 steady on light
condition of 3.5 seconds. This signal automatically repeats itself as long
as the brakes are applied. This pattern is not random, but has been selected
because of its ability to gain and retain following drivers attention.
Most states drivers
handbooks recommend that you flash your brakes when slowing or stopping. The
BackOFF-MC automatically facilitates compliance and enhances safety. Install
the BackOFF-MC and see how much more effective your brake light can be.
PLEASE NOTE:
THIS MODULE WILL NOT WORK on bikes that use L.E.D. lighting! You
will need to purchase the
BackOFF-XP
Features:
Easy Installation. -
Simply install the BackOFF-MC module in line with your brake light wire
between your brake light switch and your brake light.
Large power capacity: -
12 volts DC, Maximum Capacity 10 Amps!
Compact size. - 2-1/4"L x
1-5/8"W x 5/8"H
Sealed Weather
Resistant heat sink case.
Limited Warranty - One Year!
|
|
Click here for Shipping Rates
Free
Shipping for Purchases over $400
Brake Light Signal Modulator
Installation
Instructions
Step 1
|
Before beginning make sure your brake
and running lights are working properly.
Note: For this installation example
we are using crimp type wire connectors (Not included). The use of
these connectors is optional. The other accepted method to splicing
wires is to solder them, and then use heat shrink tubing to seal
them. In either case we have provided ample lengths of wire to splice
this module to into your brake light wire. One further note of
caution, if any bare wires are exposed as a result of this
installation, wrap the exposed wires with electrical tape to prevent
any possibility of a short circuit.
|
Step 2
|
Using a
test light, locate and note the color of the brake light "hot" (+)
wire. This wire will cause the test light to light when the brakes are
applied, and go out when they are released.
|
 |
Step 3
|
Mount the enclosed adhesive pad to
the backside of the Brake Light Signal Module. Then find a convenient
location near where you want to splice into the brake light wire.
Assure the mounting surface area is clean and free of grease or oil
prior to attaching adhesive pad (adhesive pad will gain 50% of its
strength within 30 minutes of placement and will be fully cured in 24
hours.).
|
Step 4
|
Cut the brake light wire in two
creating two ends.
|
 |
Step 5
|
Connect the two wires of the module to the
two wires that you created when you cut the brake light positive wire
in step 4.
Be sure to
connect the Red Wire from the module to the end of the wire leading to
the bike's switch, and the White wire with a red stripe to the end
of the wire leading to the bike's brake light. IF YOU DO NOT CONNECT
THE WIRES CORRECTLY THE MODULE WILL NOT WORK! |
 |
|
|
