NOTE: This XP Module Will Replace the BackOFF PN's 01002 & 01003 Modules.
Create more visibility and conspicuity when you are stopped or stopping when you install the BackOFF-XP™. 

This compact solid state electronic module converts your ordinary brake lights into your choice of two attention getting visual alerting signals when you apply your brakes: 

User Selected Mode One:
Emit a visual signal of 3 short light flashes, followed by 1 long light flash (3.5 seconds). The signal automatically repeats itself as long as the brakes are applied. This pattern is not random, but has been selected because of its ability to retain following drivers attention. 



User Selected Mode Two:
Emit a visual signal of 5 short flashes, followed by a steady on light that remains steady on as long as the brakes are applied. 

Optional:
Motorcycle Emergency Flasher or Automobile Back-Up Flasher.

Most states drivers handbooks recommend that you flash your brakes when slowing or stopping. The BackOFF-XP™ automatically facilitates compliance and enhances safety. Install the BackOFF-XP™ and see how much more effective your brake light can be.

BackOFF-XP™
Installation Instructions

Mode One Installation for - 3 Short Flashes / 1 Long Flash (Repeat):

• Before you begin…make sure your brake lights are working properly!

• Locate brake light wire (leading to the vehicles center brake light).

• Cut and splice Module into brake light wire (see schematic below).  Secure "Red Wire" from Module to wire leading from "Brake Light Switch". Secure "White Wire with Red Stripe" from Module to wire
  leading to the brake light.

• Connect "Black Wire" to Ground.

• Secure BackOFF XP Brake Light Signal Module with included double-
  sided adhesive tape.
  
  
  

Mode Two Installation for - 5 Quick Flashes & Steady On:

• Before you begin…make sure your brake lights are working properly!

• Locate brake light wire (leading to the vehicles center brake light).

• Secure "Red Wire" from Module to wire leading from "Brake Light Switch". Secure "Red Wire with White Stripe" from Module to wire leading to the brake light.

• Connect "Black Wire" to Ground.

• Secure BackOFF XP Brake Light Signal Module with included double-sided adhesive tape.
  
  
  

OPTIONAL EMERGENCY FLASHER FOR MOTORCYCLES
Causes Brake Lights To Blink Continuously When Switch Is Closed

OPTIONAL BACK-UP FLASHER FOR AUTOMOBILES
Causes Center Brake Light To Blink When Automobile Is In Reverse